Φαροσειρήνα IP66 (εξωτερικού χώρου) BENTEL FC410LPAV
The FC410LPAV is a red loop supplied addressable sounder /beacon suitable for outdoor use (IP65). It’s low consumption and it’s equipped with an embedded isolator. It’s possible to select 16 tones, 2 volumes and 2 flashing frequencies via FireClass 500 Console software.
Πλακέτα 1 εισόδου / 1 εξόδου BENTEL FC410SIO
The FC410SIO Single Input Output Module provides one volt-free relay changeover contact and one input to monitor external equipment. The input can be configured to monitor normally open or normally closed inputs.
Mini πλακέτα εισόδου BENTEL FC410MIM
The FC410MIM Mini Addressable Contact Input Module is designed to monitor external equipments. The FC410MIM provides one input and can be configured to monitor normally open or normally closed inputs.
Πλακέτα 3 εισόδων/ 4 εξόδων BENTEL FC410MIO
The FC410MIO Multi I/O Module has three inputs and four low power outputs. The inputs can monitor external equipments and can be configured to monitor normally open or normally closed inputs. All four low power outputs can drive a self-powered high voltage relay HVR800. By disabling the low voltage outputs three and four, the outputs one and two can be used as volt-free relay changeover contacts (2 A @ 24 Vdc).
Isolator module BENTEL
The FC410LI Line Isolator Module is designed to be used on the FireClass addressable loop control panel. It monitors the line condition and when detecting a short circuit will isolate the affected section whilst allowing the rest of the addressing circuit to function normally. The purpose of the FC410LI Line Isolator Module is to ensure that, on a looped addressable system, no short circuit fault can disable more detection devices than would be lost on a conventional non-addressable fire circuit.
Πλακέτα σύνδεσης αναλογικών ανιχνευτών BENTEL
The Addressable FC410DIM provides the ability to connect and interface up to two zones of 24V d.c. 2-wire conventional detectors to the FireClass 500 Control Panel. The conventional detection circuit is powered from an external 24V d.c. supply and is reset by the FireClass 500 control panel. The FC410DIM monitors the status and wiring to the detectors and the external 24V d.c.
Διευθυνσιοδοτουμενος Πίνακας πυρανίχνευσης 1 βρογχου LOOP (Fireclass)
• Δυνατότητα μετατροπής 3 συμβατικών ζωνών σε 1 βρογχο (LOOP) • 128 συσκευές στο LOOP • Πιστοποίηση EN-54 • 32 ζώνες ανίχνευσης • Αυτόματη ανίχνευση των συσκευών • Ευκολος προγραμματισμός από το πληκτρολόγιο • Λογισμικο προγραμματισμου και γραφικής απεικόνισης δωρεάν • USB θύρα για προγραμματισμό • Αποθήκευση 4000 συμβάντων • PSTNdialerμεContactID&SIAπρωτόκολλο για ειδοποίηση (FC 500PS) • IP module για απομακρυσμένη διαχείριση (FC 500IP3) • Λογισμικό για απομακρυσμένη διαχείριση ως 32 πίνακες (FC MAE)







